Reset Eprom Epson 1410 Adjustment Program New File

Technical Procedure: Resetting Epson 1410 EPROM via Adjustment Program Subject: Epson Stylus Photo 1410 Maintenance Objective: Reset Waste Ink Pad Counter (EPROM) using Adjustment Program Difficulty Level: Intermediate Risk Warning: High. Incorrect use of adjustment programs can permanently brick the printer.

1. Abstract The Epson Stylus Photo 1410 is designed with a built-in maintenance counter stored in the EPROM. This counter tracks the amount of ink flushed into the waste ink pads during cleaning cycles. When this counter reaches its factory-set limit, the printer stops functioning and displays an error message requiring service. This paper outlines the procedure to reset this counter using a "New" Adjustment Program utility. 2. Prerequisites & Safety Warnings Before proceeding, the user must acknowledge the following:

Hardware Preparation: Resetting the counter without replacing or cleaning the physical waste ink pads will result in ink overflowing from the bottom of the printer, creating a mess and potentially damaging internal circuitry. Antivirus Flags: Official Epson Adjustment Programs are often flagged by antivirus software as malware or "hack tools" because they access low-level hardware firmware. The user may need to temporarily disable antivirus protection or create an exclusion rule. OS Compatibility: Most "New" adjustment programs are designed for Windows (XP, 7, 8, 10, 11). Compatibility mode may be required for older utilities.

3. Required Materials

Epson 1410 Adjustment Program (New Version): Ensure the specific version supports the 1410 model. USB Cable: Connected securely to the PC. Computer: Running Windows OS. Absorbent Cloth: For cleaning potential leaks.

4. Step-by-Step Procedure Phase A: Hardware Setup

Ensure the printer is turned ON and connected to the computer via USB. Ensure there are no blinking error lights on the printer panel (unless the specific error is the "Service Required" message). Check that standard printing is disabled in the Windows Print Queue to prevent interference. reset eprom epson 1410 adjustment program new

Phase B: Software Execution

Extraction: Extract the downloaded Adjustment Program folder (usually a .zip or .rar file) to a location on the Desktop. Do not run it directly from the zip file. Launcher: Locate the AdjProg.exe file. Right-click and select "Run as Administrator" (Highly recommended for proper driver access). Model Selection:

The utility will open. Select "Accept" on the license agreement. In the "Model Name" dropdown, select Epson Stylus Photo 1410 (or 1400/1410 series depending on the specific build). Ensure the "Destination" matches your region (usually leave as default). Click "OK" . Abstract The Epson Stylus Photo 1410 is designed

Phase C: Port Configuration

Once the main interface appears, ensure the correct USB port is selected. It typically appears as USB001 or USB002 . Troubleshooting: If the port is not visible, check the device manager to ensure the printer driver is installed correctly.