Cutting Plotter Kh-720 Jun 2026

Users of mid-range cutters like the KH-720 often waste time and expensive vinyl due to "ghost cuts"—where the machine cuts slightly off-registration because the operator didn't perfectly align the material or the media drifted during a long job. Furthermore, converting complex JPEG/PNG logos into clean cut-files usually requires expensive, separate software.

The blade in the plotter is not a needle; it is a tiny knife edge. When the machine makes a sharp corner, the blade drags slightly behind the tip. If the software doesn't account for this, you will see rounded corners on square shapes. cutting plotter kh-720

| Button | Function | |--------|----------| | | Enter settings (offset, pressure, speed, test cut) | | ↑/↓ | Navigate / jog head left/right | | Enter | Confirm selection | | Pause | Stop cutting mid-job | | Reset/Alig | Reset origin or set start point | | Test | Perform a test cut (press after aligning head) | Users of mid-range cutters like the KH-720 often

The blade drags when moving between letters. Fix: Increase the "Up Speed" or "Pen Up Speed" in your software. Alternatively, reduce the blade offset value (start at 0.25mm for a standard 45° blade). When the machine makes a sharp corner, the